ETICS weber.therm B 100

The ETICS weber.therm B 100 can be used on masonry, concrete or panel materials.

In the case of masonry, he ETICS should be bonded with weber.therm 300, weber.therm 301, weber.therm 302, weber.therm 304 or weber.therm 346.

In the case of concrete, weber.therm 370 or weber.therm 346 should be used. 

And in the case of board materials, weber.therm 309 should be applied. 

For thermal insulation within this ETICS the polystyrene insulation boards weber.therm EPS Facade are used.

Eventually, this system can be anchored with the dowels weber.therm.

As reinforcing mortar eber.therm 300, weber.therm 301, weber.therm 302, weber.therm 304 oder weber.therm 376 can be used.

The non-sliding fiberglass fabric weber.therm 310 should be embedded in the reinforcing mortar weber.therm 300.

If other reinforcing mortars are applied, there is a choice between the coarse fiberglass fabric weber.therm 310 and or the fine one weber.therm 311.

For this ETICS there is the choice between thick-layer mineral scratch renders and thin-layer mineral, silicate or organic renders.

In the case of thin-layer mineral renders the prime weber.prim 403 can be used, if necessary.

In the case of thin-layer mineral overlay renders, paint is recommended.

If necessary, the primer weber.prim 406 can be used. After drying the paint weber.ton 411 AquaBalance or weber.ton 412 AquaBalance or weber.ton Xtreme can be applied.

Without primer, there is the choice between weber.ton 410 AquaBalance or weber.ton 414 AquaBalance.