weber.cal 286

Grain sizes: 0,5; 1,0 mm

Base color: natural white

Layer thickness: 2 - 3 mm

Storage:
The product can be stored for at least 12 months in its original unopened packaging, frost-free and away from direct sunlight at temperatures between +5 and +30 °C.

Fields of application

weber.cal 286 textured lime-based finishing plaster/render is a ready-to-use, pumped-in lime plaster for interior and exterior use on weber.dur base coats and weber.cal lime undercoat plasters, as well as on the weber.therm mineral foam interior insulation
system. Suitable as a renovation mortar for coating load-bearing, crack-free old plaster systems.

Product features

• mould-inhibiting
• ready to use
• preservative-free
• VOC-free
• free from fogging-active substances
• has an antiseptic effect
• has a resistant surface
• good adhesion
• water-repellent
• highly permeable to water vapour

General notes

• Health and environmental protection is always our top priority. Therefore, please observe the following instructions: Avoid eye and skin contact by wearing suitable protective clothing (safety goggles and gloves). Wear long trousers. If contact with eyes or skin nevertheless occurs, rinse thoroughly with water immediately and consult an (eye) doctor if necessary. The longer fresh render remains on your skin, the greater the danger of serious skin damage. Ensure thorough ventilation during and after
  application and drying. Avoid eating, drinking and smoking while you are applying the product. Keep out of reach of children and keep children away from fresh render. Use combination filter A2/P2 for spray mist.
  Do not pour the product or its residues into bodies of water, drains or onto the ground. Only dispose of completely empty containers for recycling. Clean tools immediately after use with soap and water. Material residues can be mixed with water and disposed of as construction site waste after hardening.
• Always follow the manufacturer's health and safety instructions during the application phase.
• Fresh plastered surfaces must be protected from direct sunlight, strong wind or moisture.
• Application and execution in accordance with DIN 18 350 VOB/C and DIN 18 550.
• Consumption figures refer to the minimum layer thickness and may vary depending on the surface and application. Exact consumption values must be determined by testing areas on the object.
• Adjacent components must be separated from the plaster system.
• weber.cal 286 is subject to continuous quality control through self-monitoring in accordance with DIN EN 998-1.

Special notes

• The plaster colour may deviate from the sample due to natural variations in raw material properties and drying conditions, as well as the effects of application and structure. This does not constitute a reduction in quality or a justified material complaint.
• If possible, order material for an object all at once. Mix different batches with each other.
• Constantly increased moisture, e.g. improperly executed splash water areas, dense planting in the direct vicinity of the façade, soiling or micro-organic dust (e.g. agricultural dust) can cause algae and fungal infestation.