weber.ton Xtreme

Colours:
free choice; feasibility upon request

Storage:
The product can be stored for at least 12 months in its original unopened packaging, if kept frost-free and protected from direct sunlight (at temperatures between +5 °C and +30 °C). Frost will destroy the product. After thawing it is not allowed to use it.

Fields of application

weber.ton Xtreme is used as intensive, dark tinted and abrasion-resistant paint.
For the colour design of several types overlay renders: mineral top coats (range weber.star and weber.top) as well as silicate top coats, organic top coats and silicone resin top coats (range weber.pas) in new and old buildings.
Also for the renovation of old organic paints.
For use outdoors.

Main features

• can be intensively tinted
• available with TSR (Total Solar Reflectance) technology upon request
• good covering capacity
• water-repellent
• easy application
• elastic
• lightfast
• solvent-free

General notes

• In case of repair works of old renders, make sure that the repaired surfaces correspond in structure, hardness and porosity to those of the old render, in order to avoid shading and colour deviations after completion of painting works.
• The consumption figures mentioned in this document refer to the minimum layer thickness of the render. Due to specific substrates and application variations the consumption might vary. Exact consumption must be determined on a job site mock-up (trial area).
• Comply with the national guidelines and/or standards (for ex. DIN 18550); if not issued and if necessary, request technical advice.
• If possible, order the whole material quantity for the building site in one. If any buckets of different batch numbers, mix them with one another.

Special notes

• The TSR value (Total Solar Reflectance) should be checked in the case of dark colours. On Etics (external thermal insulation composite systems) the TSR value should be ≥ 25%. Special pigment combinations of TSR technology allow obtaining particularly dark colors with higher TSR values.
• The product is factory-set to algicide and fungicide. Handle biocides carefully. Always read packaging label and product information before use.
• If a higher resistance against algal and fungal growth is requested, we recommend using the biocide-free product range AquaBalance for paints.
• Permanent high humidity level and dirt deposits for ex. in cases of application on socket areas of facades, faulty drainage and planting of trees close to buildings can promote the formation of algae and fungi.