weber.pas 480 AquaBalance

Grain sizes:
2.0 mm and 3.0 mm

Colours:
white and colours according to the Weber colour chart; special colours upon request

Application thickness:
2.0 - 3.0 mm

Storage:
The product can be stored for at least 12 months in its unopened original packaging, if kept protected from direct sunlight and frost-free (at temperatures between +5 °C and +30 °C).

Fields of application

weber.pas 480 AquaBalance is used as silicone-based overlay render (top coat) for indoors and outdoors with excellent, and durable protection against algae and fungi.
Also, suitable as finish top coat on weber.dur underlay renders (base coat) and on weber.therm Etics (external thermal insulation composite systems).

Main features

• without biocidal film preservation
• controlled hydrophilic surface with a balanced moisture management, preventing formation of algae and fungi
• easy application
• particularly weather-resistant
• very open to water vapour
• resistant to high mechanical loads
• solvent-free
• for use indoors and outdoors

General notes

• Material dries by evaporation of water. Therefore, damp weather will delay drying. Complete drying may take up to 2 weeks.
• During application and drying, the temperature of air, materials and substrate must always be above +5 °C and the relative humidity rate must be below 80%.
• Protect fresh render surfaces from direct sunlight, strong winds or moisture.
• Comply with the national guidelines and/or standards (for ex. DIN 18550); if not issued and if necessary, request technical advice.
• The consumption figures mentioned in this document refer to the minimum layer thickness of the render. Due to specific substrates and application variations the consumption might vary. Exact consumption must be determined on a job site mock-up (trial area).
• Adjacent building parts must be separated from the built-in render system.

Special notes

• After drying the render colour might vary due to natural deviations of raw materials, render structure as well as application and drying conditions. For the same reasons the render colour might deviate from the Weber dry sample or colour chart. Colour variations cannot be considered as quality loss or as justified claim.
• If possible, order the whole material quantity for the building site in one. If any buckets with different batch numbers, mix them with one another.
• In case of over-painting top renders, it is always recommended to use paints with AquaBalance technology (for ex. weber.ton 411 AquaBalance).
• Thanks to its optimized moisture management, weber.pas 480 AquaBalance offers a very high and durable protection against algae and fungal growth.
• Permanent high humidity level and dirt deposits for ex. in cases of application on socket areas of facades, faulty drainage and planting of trees close to buildings can promote the formation of algae and fungi.