weber.floor 4706

Colour:

black

Storage:

The product can be stored at least 15 months in its original unopened packaging, if kept dry and at temperatures between +5 °C and +30 °C.

Fields of application

weber.floor 4706 is used for achieving transversal conductivity when laying electro-conductive floor coverings. In general, the installation of a network with copper strips is not necessary. An electro-conductive installation is possible with the 2 other system products: the multi-use conductive adhesive weber.floor 4885 and the copper conductive strip weber.floor 4918. For use indoors.

Main features

• EMICODE EC 1: low emission of volatile substances
• GISCODE D 1: solvent-free
• electrical leakage resistance of < 3 x 105 Ohm according to EN 13415
• ready-to-use
• solvent-free
• dust-binding
• suitable on heating floor constructions

General notes

• Comply with the standards and/or national guidelines relating to flooring works. If not issued, and if necessary, request technical advice
• Relative humidity rate during application and drying: 40 - 65%; max. 75%
• Adapt the primer to room climate before application.
• The drying time and the delay for over-working with subsequent products depend on the temperature (room air and substrate), relative humidity rate, substrate porosity and amount of primer.
• The product is frost-sensitive.
• Observe the technical data sheets of the floorings and all other used products.
• Close opened packagings tightly and use the content quickly.

Special notes

• If a conductive system is installed, it must be earthed by an electrician in accordance with prevailing regulations. The electrical conductivity is measured after complete setting of all applied products.
• The resistance of the primer on non-conductive substrates is < 3 x 105 Ohm in accordance with EN 13415.
• The primer reduces the porosity of the smoothed/levelled substrate; therefore, allow for an adjusted longer flash-off time of the adhesive in case of water-vapour impermeable floor coverings.