weber.epox design New Product
Coloured epoxy resin adhesive (R2 T) and grout (RG)
Colours:
white, silver grey, cement grey, dark grey, black
Storage:
The product can be stored for at least 18 months in its original unopened packaging, if kept dry and cool at a temperature ≥ +5 °C.
Fields of application
weber.epox design is used for fixing and grouting ceramic tiles and mosaic on walls and on floors indoors and outdoors for joints with a maximal width of 10 mm.
Mainly for use in areas permanently under water like swimming pools, wellness spas, thermal, medicinal and therapy baths; in residential and public baths and in wet-duty rooms.
Also for use in facilities whenever an increased chemical resistance for tiling fixing and for grouting is necessary, like canteen kitchens, cheese dairies, dairies, breweries, beverage production facilities, butcheries, slaughterhouses etc.
Furthermore for repair of worn-out joints.
For use indoors and outdoors.
Main features
- R2 T: R2: pull-off strength ≥ 2.0 N/mm2 after all storage conditions – T: thixotropic, slip ≤ 0.5 mm
- RG: reduced water absorption (≤ 0.1 g) and higher abrasion resistance (≤ 250 mm3)
- particularly easy for grouting works and cleaning
- watertight
- brilliant colour effect
- fine surface texture
- resistant to numerous cleaners, diluted acids, lyes, salt solutions, oils etc.
- high abrasion resistance
- very easy to emulsify
- resistant to frost and thawing salts
- odourless
General notes
- All characteristics mentioned in this data sheet are based on a temperature of +23 °C without draught and a relative humidity rate of 50%.
- Higher temperatures accelerate, lower temperatures delay the reaction process.
- Comply with the national standards and/or guidelines, for ex. DIN 18157 ʺExecution of tilings and coveringsʺ and the leaflets of ZDB (Central Association of German Construction Industry); if not issued and if necessary, request technical advice.
- Do not install or grout tiles, slabs or natural stones that have been stored damp, wet, or too cold.
- Mortar residues can settle on porous (also microporous), rough and matte surfaces. If in doubt, carry out a preliminary test on a trial area. If necessary, such discolorations can be prevented by pre-wetting the grouted surfaces.
Special notes
- For natural stones and other critical coverings (polished, unglazed, non-skid, etc.), always carry out a preliminary test prior to grouting.
- There is a risk of staining or visible material residues in the pores.
- It is imperative to clarify in advance whether weber.epox design is suitable for the selected type of water treatment in baths/pools.
- Do not add water to the components during mixing and application.
- Take care when handling component B (hardener); it is alkaline, skin aggressive and can cause irritation. Observe the safety regulations indicated on the packaging when handling and storing the material.
- Colour changes due to UV rays cannot be excluded. In the event of prolonged, frequent or intensive exposure to chemicals (e.g. cleaning agents, disinfectants), discolouration may occur without impairing the properties of the product.