weber.tec 795

Colours:

standard colours approx. RAL 1001, 1015, 3009, 5014, 6011, 7001, 7015, 7023, 7030, 7032, 7035, 7040; other colours upon request

Storage:

The product can be stored up to 12 months in its original unopened packaging, if kept dry and frost-free. Frost will destroy the product. After thawing it is not allowed to be used.

Anwendungsgebiet

weber.tec 795 is used as paint for mineral substrates (concrete, screeds) with slight mechanical and chemical loads in interior and exterior areas.
Mainly for use in cellar rooms, archive rooms, corridors and industrial floor areas with requirements for colour design. Also for so-called “sensitive recreation rooms”. Furthermore, as “maintenance coat” for the maintenance of old epoxy resin coatings.
For use indoors and outdoors.

Produkteigenschaften

• EMICODE EC 1 PLUS R: very low emission of volatile substances
• fulfills the AgBB guidelines (Committee for Health-Related Evaluation of Building Products) for sensitive recreation rooms
• easy application
• dries with a silky shine
• odorless
• rapid hardening
• high solids content
• produces beautiful surfaces
• available in a wide colour range
• for use indoors and outdoors

General notes

• Comply with the national standards and/or guidelines relating to works with reactive resins on floors; if not issued and if necessary, request technical advice.
• Relative humidity rate < 75% during application and up to 24 hours afterwards
• Minor shade deviations are unavoidable due to different product batches. If a uniform colour appearance is important, work on contiguous sections should be carried out using the same batch number (see label on packaging).
• Epoxy resins are not permanently colour-stable under UV radiation and weather influences and they tend to become chalky due to accelerated ageing.
• The application of an additional wear coat with a wax-dispersion based treatment is recommended for all smooth sealers/coatings. Request Weber care instructions and/or technical advice.

Special notes

• Do not extend the processing beyond the end of pot life; otherwise, disturbances of the curing process will occur.
• For a colourless subsequent treatment (top coat) use the low-emission EP-emulsion primer weber.floor 4725.