weber.dur 126

Colour:
grey

Application thickness:
2 mm - 3 mm (in 2 layers of max. 1.5 mm each)

Water demand:
approx. 6.25 - 6.75 liters / 25 kg, depending on the required consistency

Storage:
The product can be stored for at least 12 months in its original unopened packaging if kept dry and protected from moisture.

Fields of application

weber.dur 126 is used as flexible, crack-bridging, one-component, hydraulically-setting waterproofing coating for socket parts of facades, for ex. on weber.dur underlay renders as well as on weber.therm bonding and reinforcing mortars.
Protects the applied render system against ground damp and non-pressure water.
After hardening, weber.dur 126 is waterproof, resistant to frost, weathering and aggressive groundwater (containing sulphates according to DIN 4030).
Also, suitable as base coat under ceramic tiles and slabs.
For use outdoors and indoors.

Main features

• easy application, since one-component
• purely mineral
• high yield
• high resistance to chemical and mechanical loads
• can be covered with overlay render or paint

General notes

• Protect the fresh mortar slurry from too quick water evaporation, for ensuring an optimal hardening.
• The consumption figures mentioned in this document refer to the minimum layer thickness of the mortar. Due to specific substrates and application variations the consumption might vary. Exact consumption must be determined on a job site mock-up (trial area).

Special notes

• Comply with the national guidelines relating to planning and execution of a render on the facade socket parts; if not issued and if necessary, request technical advice.
• The waterproofing product on the earth-contacting walls must cover the layers weber.dur 126 by at least 10 cm.
• weber.dur 126 must be applied at least 5 cm over the upper level of ground.