Socket waterproofing in case of timber frame constructions

1. After substrate preparation, apply the all-purpose primer weber.prim 900 on the forepart of the concrete slab and on the slab itself in the area of the upstanding wall components. Afterwards a scratch layer of weber.tec Superflex D 24 is applied. After its drying, the waterproofing under the walls is carried out in 2 layers.

2. Application of scratch layer full-surface weber.tec Superflex D 24 on the timber panelling located on the socket part.

3. Application of the first waterproofing layer weber.tec Superflex D 24.

4. Check of the wet layer thickness with the layer thickness gauge (weber.sys Schichtdickenmesser).

5. Embed the watertight foil waterproofing foil weber.sys 982 "wet-in-wet" in the reactive waterproofing layer. Lay the foil with 10 cm overlapping; it is not to be allowed to end at corners, edges and grooves (angles).

6. Carefully cover the foil with weber.tec Superflex D 24 over its entire surface.

Waterproofing of flush-floor windows

7. Fixing and bonding of the watertight self-bonding foil weber.sys 982 SK. The foil is folded up. Then the scratch coat is applied underneath, followed by the first layer of waterproofing (both with weber.tec Superflex D 24).

8. Then, the foil weber.sys 982 SK is covered full-surface with the first layer of weber.tec Superflex D 24.

9. Apply the second layer weber.tec Superflex D 24 as soon as the first cannot be damaged.

10. Ready waterproofing of flush-floor window.