weber.floor 4602

Water demand:
max. 4.5 liters/25 kg

Storage:
The product can be stored for at least 6 months in its original unopened packaging if kept dry and protected from moisture.

Fields of application

weber.floor 4602 is used as a coarse levelling layer for very uneven industrial floors (concrete or screeds) prior to application of the final cement-based levelling compounds weber.floor 4610 Industry Top, weber.floor 4650 DesignColour and weber.floor 4655 Industry ResinBase or the epoxy resin coatings (weber.floor 4740 and 4741) in a thickness ˃ 2 mm. As top wear layer (without covering) for direct use on floors with light loads, such as pedestrian traffic, hand-pulled, pneumatic-tyred carts and moderate forklift traffic with pneumatic or solid rubber tyres. For use indoors.

Main features

• EMICODE EC 1PLUS: very low emission of volatile substances
• CE marking: CT – C25 – F7 – AR1
• high flow performance and very good levelling property
• fits mechanical application very well
• very quick and economical application with weber.floor Pumptruck (mixing and pumping)
• early open to foot traffic
• can be used in different layer thicknesses (5 - 50 mm)
• fiber-reinforced
• resistance to abrasion (class AR1)
• suitable as coarse levelling layer (underlay) under reactive resin coatings
• suitable as top wear layer for vehicular traffic with light mechanical loads in industrial facilities
• self-aerating: no need of spike roller

General notes

• Comply with the national standards and/or guidelines relating to levelling works on floors. If not issued and if necessary, request technical advice.
• Assess the levelling requirement beforehand and mark the finished floor heights.
• Take over existing movement joints.
• In case of slopes (max. 1.5%) the flow performance can vary at some extent by reducing the water dosage.
• Arrange dummy joints for special structural features and special room geometry, i.e wall entry points, doorways, wall recesses.
• High temperatures shorten, lower temperatures extend the pot life.
• During application and for 1 week afterwards the ambient air and floor temperatures should not fall below 5 °C.
• Relative humidity rate during setting: max. 70%
• In case of doubt regarding application, substrate or special structural features, request technical advice.

Special notes

• Limits of use: do not use outdoors.
• The hardened surface can vary in colour and appearance depending on raw material, job site conditions and the ʺhandwritingʺof the applicator.
• The untreated surface should generally be cleaned dry by sweeping.
• In case of chemical spillage or frequent moisture protect the surface with a reactive resin coating.
• Do not add any foreign substances during mixing, pumping and application.