weber.floor 4605

Water demand:

max. 4.5 liters/25 kg

Storage:

The product can be stored at least 6 months in its original unopened packaging, if kept dry and protected from moisture.

Fields of application

weber.floor 4605 is used as high-strength industrial screed on extremely uneven industrial floor surfaces (concrete or cement screeds) for accommodating cement-based industrial floor coatings like weber.floor 4610 Industry Top and for accommodating reactive resin coatings > 1.5 mm. Dedicated for use as wear layer on floors in warehouses and production halls with light mechanical loads, e.g. pedestrian traffic, hand-pulled and pneumatic tyred carts and medium forklift traffic with pneumatic and solid rubber tyres. For use indoors.

Main features

• EMICODE EC 1 PLUS: very low emission of volatile substances
• CE marking: CT – C50 – F7 – AR0.5
• flow-grade and very good levelling property
• fits mechanical application very well
• very quick and economical application with weber.floor MixMobil
• early open to pedestrian traffic
• can be used in different layer thicknesses (30 - 100 mm)
• resistance to abrasion (class AR0.5)
• suitable as industry screed and top wear layer

General notes

• Comply with the standards and/or national guidelines relating to levelling works for floors. If not issued and if necessary, request technical advice.
• Assess the levelling requirement beforehand and mark the finished floor heights.
• Take over existing movement joints.
• In case of slopes (max. 1.5%) the flow performance can vary at some extent by reducing the water dosage.
• Arrange dummy joints for special structural features and special room geometry, i.e. wall entry points, doorways, wall recesses.
• High temperatures shorten, lower temperatures extend the pot life.
• During application and for at least 1 week afterwards, the substrate and ambient air temperatures should not fall below 5 °C.
• Relative humidity rate during setting: max. 70%
• In case of doubt regarding application, substrate or special structural features, request technical advice.

Special notes

• Limits of use: do not use outdoors.
  The hardened surface can vary in colour and appearance depending on raw material, job site conditions and the “handwriting” of the applicator.
• The untreated surface should generally be cleaned dry by sweeping.
• In case of chemical spillage or frequent moisture protect the surface with a reactive resin coating.
• Do not add any foreign substances during mixing, pumping and application.